Maxim-integrated 78M6610+LMU Evaluation Kit Manual do Utilizador descarregar pdf (Página 23)

78M6610+LMU Evaluation Kit User Manual

Rev 1 23

6.2.1 Jumper Position Changes

Move J23 and J24 jumpers to position CT to use CT2 and remove jumper at J9.

J23 Jumper Description

J23 Pins

Description

Jumper

1/2 Connect J15 SHUNT to 78M6610+LMU Sensor Slot 1 -

2/3 Connect J10 CT2+ to 78M6610+LMU Sensor Slot 1 Installed

J24 Jumper Description

J24 Pins Description Jumper

1/2 Connects J8 SHUNT to 78M6610+LMU Sensor Slot 1 -

2/3 Connects J10 CT2- to 78M6610+LMU Sensor Slot 1 Installed

J9 Jumper Description

J9 Pins

Description

Jumper

1/2 Connect AC Neutral to V3P3A (chip reference) -

6.2.2 Device Configuration

Use the Configuration tab to map the sensors as shown in the table below. Re-enter the gain value for CT2

(located on bottom of board) into the S1_GAIN register if needed.

Voltage

Current

-S2

Pre-Amp

1X S1

1X S3

Note: The values will not be displayed correctly on the Power tab of the provided GUI due to the increased

full-scale value of the voltages. Reported results for measurements will be one-half the expected magnitude.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sem comentários

Maxim-integrated 78M6610+LMU Evaluation Kit Manual do Utilizador Página 23