Maxim-integrated MAXQ7666 Manual do Utilizador descarregar pdf (Página 51)

1.4.6 System Control Register (SC)

Bit 7: Test Access (JTAG) Port Enable (TAP). This bit controls whether the Test Access Port special-function pins are enabled. The

TAP defaults to being enabled. Clearing this bit to 0 disables the TAP special function pins. See

Section 10

for more information about

JTAG and TAP.

Bits 6 and 0: Reserved. Read 0, write ignored.

Bits 5 and 4: Code Data Access Bits 1 and 0 (CDA1 and CDA0). The CDA bits are used to logically map physical program memo-

ry page to the data space for read/write access (see table below).

The logical data memory addresses of the program pages depend on whether execution is from Utility ROM or logical data memory.

Note that CDA1 is not implemented if the upper 32k of the program space is not used for the user code. No CDA bits are needed if

only one page of program space is incorporated.

Bit 3: Upper Program Access (UPA). The physical program memory is logically divided into four pages; P0 and P1 occupy the lower

32kWords while P2 and P3 occupy the upper 32kWords. P0 and P1 are assigned to the lower half of the program space and are always

active. P2 and P3 must be explicitly activated in the upper half of the program space by setting the UPA bit to 1. When UPA bit is

cleared to 0, the upper program memory space is occupied by the Utility ROM and the logical data memory, which is accessible as

program memory. Note that the UPA is not implemented if the upper 32k of the program space is not used for the user code.

Bit 2: ROM Operation Done (ROD). This bit is used to signify completion of a ROM operation sequence to the control units. This allows

the Debug engine to determine the status of a ROM sequence. Setting this bit to logic 1 causes an internal system reset if the JTAG

SPE bit is also set. Setting the ROD bit will clear the JTAG SPE bit if it is set and the ROD bit will be automatically cleared by hardware

once the control unit acknowledges the done indication. See

Section 11

for more information.

Bit 1: Password Lock (PWL). This bit defaults to 1 on a power-on reset. When this bit is 1, it requires a 32-byte password to be

matched with the password in the program space before allowing access to the password protected in-circuit debug or bootstrap

loader ROM routines. Clearing this bit to 0 disables the password protection for these ROM routines. See

Section 12

for more

information.

MAXQ7665/MAXQ7666 User’s Guide

1-49

Bit #

76543210

Name TAP — CDA1 CDA0 UPA ROD PWL —

Reset 1 0 0 0 0 0 1 0

Access rw r rw rw rw rw rw r

r = read, w = write

Note: This register is reset to 100000s0b on all forms of reset. Bit 1 (PWL) is set to 1 on a power-on reset only.

CDA1:CDA0

BYTE MODE

ACTIVE PAGE

WORD MODE

ACTIVE PAGE

00 P0 P0 and P1

01 P1 P0 and P1

10 P2 P2 and P3

11 P3 P2 and P3

Maxim Integrated

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 385 386

Comentários a estes Manuais

Sem comentários

Maxim-integrated MAXQ7666 Manual do Utilizador Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Maxim-integrated MAXQ7666