Maxim-integrated MAXQ7667 Manual do Utilizador descarregar pdf (Página 121)

6-27 __________________________________________________________________________________________________________

MAXQ7667 User’s Guide

T2P0 PIN

CODE EXECUTION:

POINT A

CODE EXECUTION:

POINT B

EVENTS:

1A: GATING CONDITION REMOVED; SINGLE-SHOT CAPTURE CYCLE BEGINS.

2A: RISING EDGE CAUSES CAPTURE/RELOAD; SINGLE-SHOT CAPTURE CYCLE ENDS; DURATION = T2C0.

1B: RISING EDGE CAUSES CAPTURE/RELOAD; SINGLE-SHOT CAPTURE CYCLE BEGINS, TIMER CLOCK GATED SINCE T2P0 PIN = 1.

2B: GATING CONDITION REMOVED; TIMER RUNS.

3B: RISING EDGE CAUSES CAPTURE/RELOAD; SINGLE-SHOT CAPTURE CYCLE ENDS; DURATION = T2C0.

Figur

e 6-8. T

ype 2 T

imer Application Example—Measur

e Low Pulse Width

6.7.9 Type 2 Timer Capture Application Examples

he following examples are used to demonstrate some of the Type 2 timer capture functions. All examples assume that pulse and/or

period measurements do not exceed 2

(i.e., 65,536) input clocks and that capture register holds the desired result.

6.7.9.1 Measure Low-Pulse Duration

To measure the duration of the first full low pulse seen on the T2P0 input pin, the Type 2 timer is configured for a single-shot capture,

ating enabled for logic high, capture on the rising edge. The CPRL2 bit can optionally be set to generate a reload on the same rising

edge as the capture if the preconfigured T2R0 value is expected to be needed next.

;

------------------ Reset State: T2R0 = T2V0 = T2C0 = 0000h ------------------------

MOVE T2CFG0, #00000010b ; T2CI =0 (sysclk/N input)

; T2DIV2:0 =000 (/1)

; T2MD =0 (16-bit)

; CCF1:0 =01 (rising edge)

; C/T2 =0 (timer/capture)

MOVE T2CNA0, #10100111b ; ET2 =1 (enable Type 2 Timer ints)

; T2OE0 =0 (input)

; T2POL0 =1 (gating level = ‘1’)

; TR2L:TR2 =00 (don’t start timer)

; CPRL2 =1 (reload on capture edge)

; SS2 =1 (single shot mode)

; G2EN =1 (gating enabled)

; ------------------ TCC2 Interrupt : DURATION = T2C0

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 346 347

Sem comentários

Maxim-integrated MAXQ7667 Manual do Utilizador Página 121